F28027

shiv parvath said:

1) Where can i find the working examples?

I suggest you start with the TMS320F28027 Product Folder.  There is a section for software.  You will find examples in the controlSUITE software package.

shiv parvath said:

2) Does it supports any RTOS?

SYSBIOS is supported on the C2000 platform, however, the F28027 may be constrained on memory resources.

shiv parvath said:

3)If it supports any RTOS, where can i find the example codes for RTOS?

The SYSBIOS package would have an example, probably a very minimal example.

Hi Brandon,

I was able to download the control suite, but which examples to use

As I used example Gpio_toggle located in ti/controlsuite/c2000 launch pad/f2802x/examples

was able to built successfully with .out file, but when I loaded the out file to device it did not work

what could be the reason?

Is there any jumper setting to be taken care on board

Regards,

shiv

Hi Shiv,

what could be the reason?

While in debug mode, did you press the play button?

Regards,

Gautam

Yes

Below are the steps in ccs

1) target configuration scan success

2)loaded gel file

3)loaded .out

4)Resume(Play button)

Is at first time we need to load any drivers for USB jtag?

Is at first time we need to load any drivers for USB jtag?

No, you don't have to. Its a one time driver installation at beginning.

I would like you to go through this step by step manual for blinking led from scratch:

7485.led_blinking.pdf

Regards,

Gautam

Ok will try with this pdf

and i'm using ccs 5.2 is it ok?

Yup, yup no problem. But its always better to be updated with the latest one. The doc that I've provided is fool proof so do upgrade your CCS if you still face any issues with your current version.

Regards,

Gautam

Gautham,

It worked.

Hi,

How can i use Sys bios on Launchpad?