f28335edsp how to generate codes by linking matlab/simulink model

deepthisree madathil

hello

iam using the processor TMSF28335. i want to generate code for my control algorithm modelled in matlab/simulink, R2010a. here is one error message i have encountered, please help me to find a solution.

matlab\r2010\toolbox\target\extensions\processor\tic2000\blks\mex\tlc_c\c280xadc.tlcline49column36

the left hand side of operator must be a. valid scope identifier

thank you

over 12 years ago

0 Gautam Iyer over 12 years ago

Guru 192875 points

Hi,

I hope you're following a similar procedure mentioned here:

https://engineering.purdue.edu/~ece495/Power_Electronics_Lab/exp2.pdf

Also, matlab related support on this forum would be limited. It would be better if you post the same in Matlab forum.

Regards,

Gautam

0 deepthisree madathil over 12 years ago in reply to Gautam Iyer

Prodigy 20 points

hello

the kit is F28335, the procedure given was F28035. its not adaptable. can you please provide the procedure for c2000 320F28335. which matlab version to use?

i would try posting it at the matlab forum concerning the error message.

thank you

0 Gautam Iyer over 12 years ago in reply to deepthisree madathil

Guru 192875 points

Hi,

In that tutorial instead of F28035, you just have to select F28335. Do check out youtube videos too:

https://www.youtube.com/results?search_query=simulink+f28335&sm=3

Regards,

Gautam

C2000™︎ microcontrollers

C2000 microcontrollers forum

f28335edsp how to generate codes by linking matlab/simulink model