F28377D dubug error help

Hi,

As a Moderator, let me move this post to c2000 microcontroller forum to be better answered by appropriate experts over there, because the query is based out of c2000 Delfino controlCARD from TI.

Regards,

Sivaraj K

hi Sivaraj K

thank you very much！

Hi,

Were you able to solve the issue?

Regards,

Gautam

Hello!,
I have the same problem and I don't know how I can resolve it. In my case, when I run the CPU1, and execute the code with breakpoints, the program runs, but when I remove the breakpoints, the CPU1 is suspended.

Thanks!!

Hi  Pablo Trujillo

      I was solve this promble in the way as follow:

      1.change CCS 5.5 to CCS6 and update debug suit into The latest version。

       2.update  controlsuit into The latest version 

after that，use the examples of 28377d support files in V110 ,and this would not happen again。

        Hope this can help you。

Thanks Guodong, Pablo was stuck with the same since a long time.

@Pablo do try the same and let us know!

Regards,

Gautam

Hello!! thanks to both.

I do all steps that yo told me, and now, the CP1 runs good, but when I press the run button for start CPU2, CCS returns me the same error but in this case with the CPU2. If I run first CPU2 the result is the same.....

Tomorrow I will try in other PC with CCS v6, because I believe that all I do is correct.

If I try to run the program from FLASH, when I programm the CPU is OK, but when I programm the CPU2, CCS is locked and closes

I will tell you tomorrow if on other PC the problem is resolved, or I have a new problems!! ;) Thanks!!

Pablo.

hi  Pablo Trujillo

      you are welcome 

       i remembered that i was only used  the examples in C:\ti\controlSUITE\device_support\F2837xD\v110\F2837xD_examples_Dual,and in my program only cpu1 is being used ,so i am sorry i never try cpu2 before.(cpu1 run in flash is ok),

        my ccs vision is Version: 6.0.0.00190 

hope these message could help you !

Hi everybody!,
Well, the microcontroller works good now. First, I have tested the MCU in other computer, but in this computer, the Controlsuite isn't updated, and the newer version that is installed, the examples are v100. When I programmed the Blibki_dc example in RAM the Microcontroller works perfectly. After, I program the FLASH and again all ok. When I come back to mi PC, first, I plug the MCU to the USB, the Microcontroller don't work!, and I only plug the power supply. I change the cable USB and again the microcontroller works perfect. I think that the USB cable that I use don't works good in this case, because I use this cable in others peripherals, and works fine. Well, I try to program the MU again with the newer version of examples, v110, and not runs. I reinstalled the CCS v6, and programmed the MCU with the V100 examples, and works perfectly again.
In conclusion, I have some problems, first, the cable not works good, I don't know the exact reason. Second, maybe I modified the v110 examples, and not works good now. Where can I download the original v110 files again?
Thanks again to all.

hi  Pablo Trujillo 

       sorry for late, if you modified program,i think you can reinstall countrolsuit in another computer and copy them .....

well before update i used files in V100,but there might some prombles ,so i suggest use files V110 only.

        hope this could help you ..

Hello, I copied the v110 examples from other PC to my PC and I programmed the Microcontroller and runs good. The problem was the USB cable.  Thanks to all!!

greetings.

Pablo.