• State Resolved
  • Locked Locked
  • Replies 5 replies
  • Subscribers 82 subscribers
  • Views 500 views
  • Users 0 members are here
Support feedback
Options
Options
Similar topics

This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

F28069 Experimental kit

Sneha Thakur
Expert 2660 points
Other Parts Discussed in Thread: CONTROLSUITE

Hi

Please share the document showing the relation of each pin on f28069 microcontroller to the output pins available on the docking station.(f28069 experimental kit)

On searching,i can only find the details and datasheets for the micocontroller but not how n which pin on the docking station has which pins output from the controller.

Thanking you in advance

Sneha

  • 0
    Guru 192875 points

    Hi Sneha,

    Sneha Thakur said:
    Please share the document showing the relation of each pin on f28069 microcontroller to the output pins available on the docking station.(f28069 experimental kit)

    You can find the same in this directory:

    C:\ti\controlSUITE\development_kits\~ExperimentersKits\DIM100ExperimentersKit-HWdevPkg_v2_0\R3

    If you don't find them, let me know the version number on your Docking station (R2/R3)

    Regards,

    Gautam

  • 0 in reply to Gautam Iyer
    Expert 2660 points

    Hi Gautam

    My experimental kit is still under process for ordering by my institute.I just wanted to go through the documents.

    As per your guidelines i searched for the document in control suite and checked both for R2/R3.But how r these related to 100-pin diagram of f28069(as per its datasheet).I could only see the ADC/GPIO pins but no CAN,SPI,SCI or other interface.

    Thanks

  • 0 in reply to Sneha Thakur
    Guru 192875 points

    Sneha Thakur said:
    My experimental kit is still under process for ordering by my institute.I just wanted to go through the documents.

    Yup, then this docking station is R3 version that can be found here:

    C:\ti\controlSUITE\development_kits\~ExperimentersKits\DIM100ExperimentersKit-HWdevPkg_v2_0\R3

    Sneha Thakur said:
    As per your guidelines i searched for the document in control suite and checked both for R2/R3.But how r these related to 100-pin diagram of f28069(as per its datasheet).I could only see the ADC/GPIO pins but no CAN,SPI,SCI or other interface.

    GPIOs are multiplexed. For example: GPIO30 is muxed with CANRXA signal, that is very much available on the docking station. So accordingly check the muxing of the peripherals and you'll find majority of them.

    *Note: Not all 100pins of F28069 are available on the docking station.

    Regards,

    Gautam

  • 0 in reply to Gautam Iyer
    Expert 2660 points

    thank u Gautam

  • 0 in reply to Sneha Thakur
    Guru 192875 points

    Sneha Thakur said:
    thank u Gautam

    You're Welcome!

    Goodluck & Regards,

    Gautam