Because of the Thanksgiving holiday in the U.S., TI E2E™ design support forum responses may be delayed the week of November 23.

This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

UART Transciever Isolated or Nonisolated ?? ... How to decide??

Other Parts Discussed in Thread: F28M35H52C

Hello All,

I have an requirement to design UART interface. Details are below.

Full Duplex, Speed up to: 6Mbps Controller: F28M35H52C.

I am planning to use RS-422 transceivers for physical layer implementaion. 

But, i am not sure, which transceiver to use: Isolated..?? or Non Isolated ..??

How to decide?? Please suggest.

Thanks in advance.

Regards,

Govind.

  • Hi Govind,

    Govind K said:
    But, i am not sure, which transceiver to use: Isolated..?? or Non Isolated ..??

    Both of them perform the same but when it comes to get your system certified (UL, CE etc) Isolated communication signal is a must.

    Regards,

    Gautam