c2000 GPIO output

Michael Lee60

Prodigy 20 points

Other Parts Discussed in Thread: CONTROLSUITE, SPRC097

hi,

Im new to the c2000. How I set GPIO as output?

I dont believe it is working properly.

do you have examples or header files?

-Michael

over 11 years ago

0 Julian Di Matteo over 11 years ago

TI__Expert 4085 points

Hi Michael,

Did you set the corresponding GPxDIR bits in order to configure the GPIO/S as an output?

What c2000 device are you using?

Thanks,

Julian

Please click the Verify Answer button on a post if it answers your question.

0 Julian Di Matteo over 11 years ago in reply to Julian Di Matteo

TI__Expert 4085 points

Michael,

Here is a link to the code examples/header files:

http://www.ti.com/mcu/docs/mcuprodcodeexamples.tsp?sectionId=96&tabId=1470

Hope this helps!

Thanks,

Julian

Please click the Verify Answer button on a post if it answers your question.

0 Gautam Iyer over 11 years ago

Guru 192875 points

Hi Mike,

Did you already install controlSuite? Please install the same for sample codes and also are you using C2000 launchpad or some other controller from C2000 series?

Regards,
Gautam

0 Michael Lee60 over 11 years ago in reply to Gautam Iyer

Prodigy 20 points

hi Gautam,

whats advantage of controlsuite over CCS?

thank you
mike

0 Gautam Iyer over 11 years ago in reply to Michael Lee60

Guru 192875 points

controlSuite is just a suite that has all example codes for the C2000 devices. Something like this:

Regards,

Gautam

0 ashutosh bhatt over 11 years ago

Expert 1490 points

First you down load sprc097.zip from TI site in which some code examples are there to understand.

http://www.ti.com/tool/sprc097

If you have your custom hardware , you need to configure boot pins as per given example requirement and try to run these code.

Regarding GPIO you just need to take care about corresponding MUX bit. after data direction bit.

hope you will get what you want in that zip file.

Good luck

Ashutosh Bhatt

C2000™︎ microcontrollers

C2000 microcontrollers forum

c2000 GPIO output