How to recover the PLC kit to original?

wayne lu1

Expert 1255 points

My PLC kit had program some code with CCS quite a while.

And now, I try to use the Zero Configuraion GUI but it says "No PLC kits were found".

How to solve this problem?

Wayne

over 11 years ago

0 Gautam Iyer over 11 years ago

Guru 192875 points

Hi Wayne,

How to solve this problem?

Which kit is this? Can you specify then Kit code? Is it TMDSPLCKIT-V3?

Regards,
Gautam

0 Igor Gorbachev over 11 years ago

Guru 20525 points

Hi.
For using Zero Configuraion GUI you need to return to pre installed original TI firmware of KIT. You can apply an embedded flasher of CCS (for .out format) or C2Prog Code Skine (for .hex format) for it.

Regards,
Igor

0 wayne lu1 over 11 years ago in reply to Gautam Iyer

Expert 1255 points

Oh, right!
I'm using TMDSPLCKIT-V3.

0 wayne lu1 over 11 years ago in reply to Igor Gorbachev

Expert 1255 points

Hi
What .out format I need to get?
What is this .out's file title?
Wayne

0 Igor Gorbachev over 11 years ago in reply to wayne lu1

Guru 20525 points

Wayne,
I hope you have some PLC Development Package. Then refer to folder SW/BIN, where an original firmware is (something like prime(g3)_iec432_f2806x.hex or prime(g3)_iec432_f2806x.out).

Regards,
Igor

0 wayne lu1 over 11 years ago in reply to Igor Gorbachev

Expert 1255 points

Igor,
Yes, I have hex and sbin but I don't have out.
But how to use these to flash on CCS.
Thanks for help me.
Wayne

0 Igor Gorbachev over 11 years ago in reply to wayne lu1

Guru 20525 points

Wayne,

you can download C2Prog utility and load with one a .hex image into your KIT.

Regards,

Igor

0 wayne lu1 over 11 years ago in reply to Igor Gorbachev

Expert 1255 points

Igor,
Thanks, It can works now.
Wayne

0 Igor Gorbachev over 11 years ago in reply to wayne lu1

Guru 20525 points

I'm glad, good luck.
Igor

C2000™︎ microcontrollers

C2000 microcontrollers forum

How to recover the PLC kit to original?