Wrong Quick Start Guide Shipped With My Unit

Hi Arne,

You can refer this:sprabn7.pdf

Regards,

Gautam

Ok, but this also looks like it's about the DRV8312 baseboard (see Figure 1). Is there documentation about the DRV8301? The board I have does not look like the ones in the documents...

This document applies for the above kit too.

"For this lab we are using the Three Phase BLDC Motor Kit with DRV8312 and Piccolo™ MCU

(DRV8312-C2-KIT) (the DRV8302-HC-C2-KIT or DRV8301-HC-C2-KIT can also be used) with a Piccolo

F28035 controlCARD™ subsystem to run the sensorless InstaSPIN™ BLDC technique. "

You can follow the same procedure.

Regards,

Gautam

Maybe applicable, but I'm new to this so it's not straightforward...

The baseboard doesn't look like the DRV8312 which is specifically addressed in the document, and there are specific instructions on pushing buttons, changing jumpers, etc.

I'd appreciate it if the documentation for the DRV8301 specifically were available somewhere.

I'd appreciate it if the documentation for the DRV8301 specifically were available somewhere.

That's what I'm trying to convey that there's no document specific to this device.

Regards,
Gautam