• State Resolved
  • Locked Locked
  • Replies 1 reply
  • Subscribers 82 subscribers
  • Views 428 views
  • Users 0 members are here
Support feedback
Options
Options
Similar topics

This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

SCI Interface in eZdsp 28335 using RS-232 Connector

Rasesh Dave
Prodigy 150 points
Other Parts Discussed in Thread: CONTROLSUITE

I am using eZdsp 28335 Starter Kit and running example "Example_2833xScia_FFDLB.c". Its working fine.

I am able to see SCI waveform on CRO from Pin No. 58 of Connector p2 "GPIO29_SCITXDA_XA19".

But I am not able to get any signal at Connector P12 (RS-232 Connector).

Is there any other Examples to use RS-232 Connector??

  • 0
    Guru 192875 points
    Hi Rasesh,

    If you've controlSuite, you can refer this this example code for PC communication via RS-232 :
    C:\ti\controlSUITE\device_support\f2833x\v133\DSP2833x_examples_ccsv4\sci_echoback

    Regards,
    Gautam