Other Parts Discussed in Thread: MOTORWARE, TMS320F28027, UNIFLASH
hi,
i am using a F28027 launch-pad in CCS6.
until today i used to build and debug the labs from motorware project labs.
but today a error created before debuging like the pic below.
also i tested the connection by launching TMS320F28027_xds100v2.ccxml in target configuration and the result was fine as seen in the pic below.
how could i solve this problem?
is it possible that the F28027 had been damaged?
thaks.
i changed the F28027 of Launchpad, now the target configuration set properly.
the test connection succeed like the picture below.
but uniflash still give the same message like pic below:
and the debug connection in CCS6 don't work and the load program error showed up.
is it possible that the launchpad damaged?
or i must change the f28027 again?
hi,
the problem solved by changing the F28027 IC. maybe the IC has been damaged.
now another problem appears.
when i develop my project code and add a piece of code in mainISR(in proj_lab5b) the load program error display and when i delete this piece of code, the code debug right and without problem.
can you help me to understand what is the problem? how can i find it?
hi,
i test the program again. this error is not only because of that piece of code, any code that i add to project may cause that problem.
also i use uniflash to program that project .out file. and the result is:
what do you think about this problem and how can i fix it?
'If you check the F28027 launchpad's schematics, you'll be able to observe S1 switch for boot settings:msadegh agha85 said:how can i configure that?
Also, in datasheet you'll find the boot mode settings:
Regards,
Gautam
