Encountered a problem loading file Could not open file: ...............................

Hi Sergio,

Which example are you having issue with? Could you please provide some more information about the issue you are having?

Thanks,
Ozino

i want flash one led in my control card. Control card is TMDSCNCD28335PGF and i have a small program to turn on a LED. This program is as follows:


#include "DSP2833x_Device.h"

#define EXAMPLE1 1

void Gpio_setup1(void);
void Delay_1ms(long);
void InitPieCtrl();
void InitSysCtrl();
void InitPieVectTable();

void main(void)
{

InitSysCtrl();

DINT;

InitPieCtrl();

IER = 0x0000;
IFR = 0x0000;

InitPieVectTable();


#if EXAMPLE1

Gpio_setup1();

#endif // - EXAMPLE1

while(1)
{
GpioDataRegs.GPASET.bit.GPIO31 = 0xFF;
GpioDataRegs.GPBTOGGLE.bit.GPIO34 = 0xFF;
Delay_1ms(1000);

GpioDataRegs.GPBSET.bit.GPIO34 = 0xFF;
GpioDataRegs.GPATOGGLE.bit.GPIO31 = 1;
Delay_1ms(1000);
}
}

void Gpio_setup1(void)

{

EALLOW;

// Enable an GPIO output on GPIO6, set it high
GpioCtrlRegs.GPAPUD.bit.GPIO31 = 0; // Enable pullup on GPIO31
GpioDataRegs.GPASET.bit.GPIO31 = 1; // Load output latch
GpioCtrlRegs.GPAMUX2.bit.GPIO31 = 0; // GPIO31 = GPIO31
GpioCtrlRegs.GPADIR.bit.GPIO31 = 1; // GPIO31 = output

// Enable an GPIO output on GPIO6, set it high
GpioCtrlRegs.GPBPUD.bit.GPIO34 = 0; // Enable pullup on GPIO34
GpioDataRegs.GPBSET.bit.GPIO34 = 1; // Load output latch
GpioCtrlRegs.GPBMUX1.bit.GPIO34 = 0; // GPIO34 = GPIO34
GpioCtrlRegs.GPBDIR.bit.GPIO34 = 1; // GPIO34 = output

EDIS;
}

void Delay_1ms(long end)
{
long i;
for (i = 0; i < end; i++);
}

But i dont have error in my program, the error is as follows:

- #10010 errors encountered during linking; "PrimeraPrueba.out" not built
- unresolved symbol _GpioCtrlRegs, first referenced in ./main.obj
- #10234-D unresolved symbols remain

Yes, but the fisrt problem aforementioned is the real problem because the others i find the solution.

The problem is: #10010 errors encountered during linking; "PrimeraPrueba.out" not built

I think the problem is how to debug the code, but i dont know if the form how i debug the code is incorrect or the problem is for other thing.

Thanks

Sergio Valencia