F28379D Delfino Experimenter Kit & Control Card

Archit Shah

Other Parts Discussed in Thread: CONTROLSUITE, TMDSCNCD28379D

Hello,

I am looking for the documentation for the F28379D Delfino Experimenter Kit and F28379D controlCARD for C2000 Real time control development kit. This has a dual core Delfino C2000 MCU. I am looking for details such as Getting Started with the Control Card & Development Kit, Schematics, Pinouts, etc.

www.ti.com/.../tmdsdock28379d

http://www.ti.com/tool/tmdscncd28379d#descriptionArea

I appreciate your time and thank you for your help.

Regards,

Archit

over 8 years ago

0 Billy Stevers over 8 years ago

TI__Prodigy 350 points

Archit,

All of the documentation can be found within controlSUITE at the location:

C:\ti\controlSUITE\development_kits\~controlCARDs\TMDSCNCD28379D_v1_0

The infosheet will have the basics of the controlCARD along with the errata and configuration settings. Pinouts and hardware information can be found within the R1_3 folder.

Hopefully this is what you are looking for!

Kind regards,

Billy Stevers

0 Matt Overlin over 8 years ago in reply to Billy Stevers

Prodigy 130 points

what is the relative distance from the 120-pin connector to the 60-pin connector below it? I'm using Altium, and I can't seem to open any of the provided files and see dimensions like this.
Thanks,
Matt

0 Brett Larimore over 8 years ago in reply to Matt Overlin

TI__Guru 57255 points

Hi Matt,

The following file should be able to be loaded into Altium via its importers and then help you measure the distances you want: {TXN003}_controlCARDDockingStationR4_1-PADS.asc

This file can be found inside controlSUITE at the following directory:
\controlSUITE\development_kits\~ExperimentersKits\120or180pin_HSEC_DockingStn-HWdevPkg_v1_1\R4_1\

Thank you,
Brett

0 user4784749 over 8 years ago in reply to Brett Larimore

Prodigy 10 points

I get the following message when I try to import that .asc file in Altium.

Please advise.

0 Brett Larimore over 8 years ago in reply to user4784749

TI__Guru 57255 points

Hi User,

I am able to import the file properly.

Another option is to look at the controlCARD connector used in the Vienna rectifier TI-Design:
\controlSUITE\development_kits\tidm_1000\v1_00_00_00\hardware\

Hopefully this helps.

Thank you,
Brett

0 Matthew Overlin over 8 years ago in reply to Brett Larimore

Prodigy 50 points

In response to the post on Dec 23, 2016 9:00 PM: I still can't open the files. Brett, if you don't mind, could you just do a quick check to see what this dimension is? That's all I need to know. That is, the vertical distance between the 2 orange holes indicated in the picture.

Thanks! Much appreciated!

Matt

0 Brett Larimore over 8 years ago in reply to Matthew Overlin

TI__Guru 57255 points

Hi Matt,

Your J8 connector is mistakenly rotated 180degress. Please see the attached.

Thank you,
Brett

C2000™︎ microcontrollers

C2000 microcontrollers forum

F28379D Delfino Experimenter Kit & Control Card