TIDA-00366 example code

Emre Uzun

Other Parts Discussed in Thread: TIDA-00366, CONTROLSUITE, MOTORWARE

I am trying to learn how to generate 3- phase signal using microcontroller recently.I found that TIDA-00366 reference design and looks so useful .

I just wondering is there any example code related to TIDA-00366? Can I use powerstudio to run the TIDA-00366 design?

thanks

Regards

over 9 years ago

0 ChrisClearman over 9 years ago

TI__Guru** 119680 points

SW is not provided for most TI Designs. My understanding for this one is it was a very simple open loop volts per Hz application that was used to prove the HW only.

If you are looking for software to control induction motors I would recommend controlSUITE TMDSHVMTRPFCKIT examples or MotorWare based InstaSPIN-FOC example (this runs on any low voltage or high voltage supported kit).

0 Emre Uzun over 9 years ago in reply to ChrisClearman

Prodigy 30 points

thank you very much for your help .I am going to use them

C2000™︎ microcontrollers

C2000 microcontrollers forum

TIDA-00366 example code