TMS320F2808: TMS320F2808 loading program via XDS100

user4318460

Part Number: TMS320F2808
Other Parts Discussed in Thread: CONTROLSUITE

Hello,

I would like to ask you for an advice. Can you
tell me whether it is possible to load program
into the memory of TMS320F2808 DSP through emulator
XDS100v2 from Code Composer Studio debuger and
then disconnect the emulator from the DSP and let
the DSP processing the loaded program independently
on the emulator? Eventually how to do that? Thank you in advance.

over 9 years ago

0 Vivek Singh over 9 years ago

TI__Guru** 116601 points

Yes, you can load the program via XDS100v2 emulator and then disconnect the emulator and power cycle the board to run the loaded program independently. Please make sure the BOOT pin settings are set to BOOT to Flash mode on board.

Regards,
Vivek Singh

0 Gautam Iyer over 9 years ago

Guru 192875 points

In addition to Vivek's comments, you can simply load this project that can be found in controlSuite for standalone (flash) operation:
C:\ti\controlSUITE\device_support\F280x\v170\DSP280x_examples_ccsv4\flash_f2808

Regards,
Gautam

0 user4318460 over 9 years ago in reply to Vivek Singh

Intellectual 620 points

Thank you very much for your reaction Vivek Singh. Please can you refer me to any document
where the BOOT pin settings is described? Thank you in advance.

0 Gautam Iyer over 9 years ago in reply to user4318460

Guru 192875 points

user4318460 said:
Please can you refer me to any document
where the BOOT pin settings is described? Thank you in advance.

Refer datasheet Section 3.2.9

0 user4318460 over 9 years ago in reply to Gautam Iyer

Intellectual 620 points

Excuse me Gautam, my question was asked in bad manner. I have following situation.

I am connected to the target DSP from CCS v6 via XDS100v2 emulator. I am

interested in possibility to load the program into the flash memory via emulator through

CCS and then disconnect the emulator and let the software run independently.

C2000™︎ microcontrollers

C2000 microcontrollers forum

TMS320F2808: TMS320F2808 loading program via XDS100