TMS320F2811 loading a program

Nidhi Rao

Other Parts Discussed in Thread: TMS320F2811, UNIFLASH

Hello All,

I have a .out file programmed for DSP TMS320F2811. I want to load the '.out' file in the DSP. How can I do this. I have JTAG programmer TMDSEMU100V2U-14T programmer.

Please reply ASAP

Thanks and regards,

Nidhi

over 8 years ago

0 Manoj Santha Mohan over 8 years ago

TI__Guru 55700 points

Nidhi,

Please refer to below document to know about different flash programming solutions

You also have Uniflash / codeskin and other 3rd party flash programming solutions.

Regarwds,

Manoj

0 Nidhi Rao over 8 years ago in reply to Manoj Santha Mohan

Prodigy 220 points

Hello Manoj,

Thank you for your response. Actually I do not have the project file. I just have .out file which was built in the CCS V 3.10 and SD Falsh ver5.0. I am using CCS v7 with TMDSEMU100V2U to load the program.
DSP Part No: TMS320F2811

Thanks and regards,
Nidhi

0 Manoj Santha Mohan over 8 years ago in reply to Nidhi Rao

TI__Guru 55700 points

Hope you were able to program F2811 with your COFF file (.out)

0 Nidhi Rao over 8 years ago in reply to Manoj Santha Mohan

Prodigy 220 points

I was able to program using UniFlash. Thanks!

C2000™︎ microcontrollers

C2000 microcontrollers forum

TMS320F2811 loading a program