Matching relationship about EVM and control card

chao yang

Other Parts Discussed in Thread: DRV8301-69M-KIT, TMDSCNCD28035ISO, CONTROLSUITE, MOTORWARE, INSTASPIN-BLDC, DRV8301

Hello all

1.I have already got DRV8301-69M-KIT,Can I use DRV8301EVM and TMDSCNCD28035ISO instead of TMDSCNCD28069MISO to control a IPM motor by controlSUITE?

2.Is there a IPM motor matched with EVM of TI ?

chao

over 8 years ago

0 ming chen3 over 8 years ago

Intellectual 775 points

Hi yang,

I see your some posts,I think we are doing the same direction about motor control .

and I want to communicate some questions with you .

my email: 15501149432@163.com.

Please email me back.

thanks~

0 Yanming Luo over 8 years ago

TI__Guru** 115430 points

1.I have already got DRV8301-69M-KIT,Can I use DRV8301EVM and TMDSCNCD28035ISO instead of TMDSCNCD28069MISO to control a IPM motor by controlSUITE?
A: Yes if you didn't use InstaSPIN, and only use the open source reference in controlSUITE.

2.Is there a IPM motor matched with EVM of TI ?
A: Please link to TI website which has some reference motor for different EVM kits.

0 ChrisClearman over 8 years ago in reply to Yanming Luo

TI__Guru** 119500 points

We do not sell a motor with high enough saliency to consider it a true IPM.

Yes, you can use same DRV8301 RevD EVM baseboard with 69MSIO card and MotorWare/InstaSPIN-FOC/InstaSPIN-MOTION or with 35ISO/69ISO card for controlSUITE based eSMO or InstaSPIN-BLDC.

0 chao yang over 8 years ago in reply to ming chen3

Expert 1620 points

ming

Welcome exchange correction.This is my personal mailbox: yangchao@protonmail.com

chao

0 chao yang over 8 years ago in reply to ChrisClearman

Expert 1620 points

chris

If I need control motor with resolver sensor,I asked whether I could use J8 (SPI interface) on Drv8301 EVM?
Which settings to change about the hardware abstraction layer?Or are there any other considerations I need to know?

chao

C2000™︎ microcontrollers

C2000 microcontrollers forum

Matching relationship about EVM and control card