TMS320F28379D: CAN Calibration Protocol (CCP)

Kash Olia

Part Number: TMS320F28379D

I'm a little confused on how to use CAN Calibration Protocol in Simulink. I followed the Mathwork examples but at the end I don't know how to monitor/calibrate the parameters. Does anybody here have any experience working with CCP in Simulink?

Thanks,

--Kash

over 8 years ago

0 Brian McKay over 8 years ago

Mastermind 9005 points

Hello Kash,

I'm not sure how to answer your question. The doc page (login required) is here:

https://www.mathworks.com/help/supportpkg/texasinstrumentsc2000/examples/can-calibration-protocol-and-external-mode.html

Note that the CCP stuff is configured for Vector-Informatik CAN hardware and drivers, which must be setup on your host computer - with baud rate set to 1M to match processor CAN configurations.

-Brian

C2000™︎ microcontrollers

C2000 microcontrollers forum

TMS320F28379D: CAN Calibration Protocol (CCP)