• State Resolved
  • Locked Locked
  • Replies 3 replies
  • Subscribers 83 subscribers
  • Views 884 views
  • Users 0 members are here
Support feedback
Options
Options
Related

This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

TMDSHVMTRPFCKIT: HVACIMTR motor

Arash Tahghighi
Intellectual 630 points
Part Number: TMDSHVMTRPFCKIT
Other Parts Discussed in Thread: CONTROLSUITE

I am going to work on induction motor drive system  and i want to buy HVACIMTR motor, but today when I checked ti website i found out it was not there for sale, does and body know where can I buy this motor?

  • 0
    TI__Guru** 119670 points
    We stopped selling the HVACIMTR because the manufacturer changed the specifications without informing us. The ACI software in controlSUITE is tuned for the parameters of the motor we originally shipped. We do not think you can find the same motor manufactured any longer.
  • 0 in reply to ChrisClearman
    Prodigy 60 points

    Please request your support:

    I am currently working on a project to control the position of a three-phase induction motor with the KIT for sensored vector control and I need to know if I have to make some additional adjustments to use the kit with a motor of 1HP (746 W) 220 V and 60 HZ instead of the motor that usually comes with the kit which is 0.25 HP. Then I want to know what? and where ? I must configure the program or the hardware since the program of the code composer simply stops when the voltage of the VARIAC increases when I rise to more than 130 V the program stops but the engine continues to run.

    I clarified that I connected the encoder and the motor correctly, I changed the encoder correctly in the software but still the program continues to stop and an error appears:

    The value is '-151' (0xffffff69). The title is 'SC_ERR_FTDI_OPEN'. One of the FTDI driver functions used during the connect returned bad status or an error. 


    I also clarify that I have already modified several parameters of the file "settings.h", like the peak current and the motor parameters.

    thanks for you comments.

  • 0 in reply to cesar paz
    TI__Guru** 119670 points
    I would suggest starting a new post on your question.
    But yes, you need to make changes for a new motor. Please read the full documentation for the project.