LAUNCHXL-F28377S: How to use the source in the ControlSuite

can you give more details of what exactly you are trying to do. Are you trying to map the source code while debugguing ?

I'm in initial stage and the programm has not been written and I'm reading the information based on the reply to 'ditital filter' . i.e. ControlSuite support.

The "doc" folder will provide documentation for any library you are looking at. Use CCS import to import examples that you show above.

Best regards
Chris

Here is the import result:

After updating the ControlSuite there are many erros during installing. The ControlSuite is not able to opened.

Try going to the "Project" tab and importing through there. You will have to navigate to the folder of the project through CCS.

Best regards
Chris

The ControlSuite is not able to be opened and I have downloaded the new software and installed but there are some problems. I'm consulting the ControlSuite support.

In the past, I have had problems installing ControlSuite using web installer. From that point on, I install using offline installer - I have had much better success using the offline installer.

Hopefully, that helps.

I have ccs3 in our lab and we run the BLDC with it, Its working fine in my computer , but the problem is how to get the data from the QEP , ADC and the sensor , I use sprc179 to control the position and speed , I got where I can control the speed but not the position. If you want further information I will send you the code.

Sudhansu

Please create a new post. Thank you.

Jingtai,

If you can't launch the GUI, delete the metadata folder before opening (Located at C:\ti\controlSUITE\eclipse\workspace)

Also, as Todd mentioned, the offline zip installer is the better option if think it isn't installing correctly.

Best regards
Chris

It is the offline installer. It has been settled based on support from TI.

Thank you.

Thank you. I'll inform you when I require the reference.