TMS320F28035: Obtaining the graph with higher resolution in CCS

Samir Gautam

Part Number: TMS320F28035

Hi Everyone!

I want to plot the signals in the CCS watch window. The highest display rate is 100ms but with this, i cannot plot the signal with high frequency, even the sine wave at 50Hz. What is the best way to plot the high frequency signals if i do not have emulator with me while minimizing the delay between the real time and display.

Thank you so much!!

Best Regards

Samir

over 7 years ago

0 Gautam Iyer over 7 years ago

Guru 192875 points

Hi Samir,

Display rate less than 100ms can be erroneous. Also, CCS and Debugger together don't support anything less than that. DSO is the best alternative here.

Regards,
Gautam

0 Samir Gautam over 7 years ago in reply to Gautam Iyer

Prodigy 220 points

Hi Gautam

Thank you so much for your prompt response. I am saving the datas in array and then display it on graph later, though it has some delay associated with it. I will also try the method you have mentioned.

Best Regards
Samir

C2000™︎ microcontrollers

C2000 microcontrollers forum

TMS320F28035: Obtaining the graph with higher resolution in CCS