TMS320F28035: LIN protocol on f28035 piccolo

ali tatar

I use experimenter kit f28035 piccolo and I want connect to "Inomatic battery sensor" with LIN protocol , the Inomatic battery sensor have one wire lin bus , how to connect battery sensor and f28035?

Should I use the transceiver ? f28035 have LINRX and LINTX pins but battery sensor have one wire LIN

best regard

over 8 years ago

0 Gautam Iyer over 8 years ago

Guru 192875 points

Hi Ali,

Yes, you need a transceiver.

Regards,
Gautam

0 Mark Labbato over 8 years ago

Guru 30330 points

Ali,

Gautam is correct. You do need a transceiver.

The sensor you are using likely has the transceiver embedded in the packaging. The F28035 does not.

Here are some transceivers that TI provides. http://www.ti.com/interface/can-lin/products.html#p1389=LIN&p1498=Automotive. You would connect LINTX and LINRX on one side and the single wire LIN bus on the other.

Thanks,
Mark

0 ali tatar over 8 years ago in reply to Mark Labbato

Prodigy 50 points

Thank you Gautam and Mark for the reply.

0 Gautam Iyer over 8 years ago in reply to ali tatar

Guru 192875 points

You're Welcome!

Goodluck & Regards,
Gautam

C2000™︎ microcontrollers

C2000 microcontrollers forum

TMS320F28035: LIN protocol on f28035 piccolo