How to run and exmple on f2812 ezdsp baord with matlab

Ahmed Shakeel

I have digital spectrum ezdsp f2812 board. I have run using ccs 3.3 the GPIO toggle example project from (C281x C/C++ Header Files and Peripheral Examples - SPRC097 - TI Software Folder). Can any one help me how to run any example on this board by connecting it with matlab 2007 rev 2009a, I have checked that my matlab support this board.

Ahmed Shakeel

over 14 years ago

0 Thanh Dang over 14 years ago

Prodigy 40 points

Dear ,

I'd like to have a question.I've read in Matlab help, that i can use Matlab/Simulink RTW Embedded Code for Board F2812 eZdsp™.

I've loader XDS510LC, chip F2812. C Code is loaded over JTAG. Is it possible to use auto generated C Code as with my hand written C Code (loading and debuging), with my own hardware without board F2812 eZdsp™ ?

Is there any hardware to connect with Matlab and to load auto generated C Code on Flash memory of Chip F2812 (not on-board) ?

Thanks and best regards

0 ChrisClearman over 14 years ago in reply to Thanh Dang

TI__Guru** 119510 points

for both of these questions I suggest you ask on the Mathworks forum, or email their C2000 support. You can get to both from here

http://www.mathworks.com/c2000

0 Ahmed Shakeel over 14 years ago in reply to ChrisClearman

Intellectual 410 points

Hi Chris

Thanks for the suggestion, i hope c2000 forum at mathworks.com will be helpful.

Ahmed Shakeel

C2000™︎ microcontrollers

C2000 microcontrollers forum

How to run and exmple on f2812 ezdsp baord with matlab