TMS320F28377S: Running example "usb_host_msc" on F28377S LaunchPad

sam kh

Expert 1635 points

Part Number: TMS320F28377S
Other Parts Discussed in Thread: C2000WARE

Please any one can tell how to run control suit example " usb_host_msc" on F28377S LaunchPad.

I not fount SCI A and USB pins on F28377S LaunchPad.

over 8 years ago

0 Sal Pezzino over 8 years ago

TI__Mastermind 32995 points

Hi,

USB pins are not mapped to any USB connector on the Launchpad. Perhaps the USB GPIOs are available though. I will ask another engineer to confirm this.

Also, SCI pins should definitely be pinned out.

sal

0 Mark Labbato over 8 years ago in reply to Sal Pezzino

Guru 30330 points

Sam,

SCIA is brought the the JTAG USB Connector though GPIO84 and GPIO85. These are accessible using the backchannel UART of the on-board XDS100v2.

Each boosterpack header also has SCI available at the standard UART location.

Regards,
Mark

0 Mark Labbato over 8 years ago in reply to Mark Labbato

Guru 30330 points

Also, GPIO42 and GPIO43 - the GPIOs with USB functionality are available on J1.9 and J1.10. Please see http://www.ti.com/lit/SPRUI25 for the users guide which shows the schematic, and boosterpack pinouts.

Thanks,
Mark

0 sam kh over 8 years ago in reply to Mark Labbato

Expert 1635 points

I having one doubt In FATFS folder give in control suite there is a file "sample_mmc" contain a header "#include<avr/io.h>". This is use for ATMEL ATMEGA micro controller. So just I want to know it is used here also?
Because when I try to compile it on CCS then it give error "file not found".

0 Sal Pezzino over 8 years ago in reply to sam kh

TI__Mastermind 32995 points

This file should be being used. Please use the software package C2000Ware. C2000Ware contains our latest updates.

Regards
sal

C2000™︎ microcontrollers

C2000 microcontrollers forum

TMS320F28377S: Running example "usb_host_msc" on F28377S LaunchPad