TMDSRSLVR: C2000 Resolver to Digital Conversion Kit.

Antonio Borelli

Part Number: TMDSRSLVR

I would like to interface my Tamagwa Resolver, using this Resolver to Digital Conversion Kit, with Launchpad F28069M. is it possible? Do I need other components?

over 6 years ago

0 Ramesh Ramamoorthy over 6 years ago

TI__Mastermind 27240 points

Yes, you can use. The kit should be sufficient.

0 Antonio Borelli over 6 years ago in reply to Ramesh Ramamoorthy

Prodigy 50 points

Thank you. I have another problem: I read, in the white papers, that this C2000 Resolver to Digital Conversion Kit, feeds a resolver with excitation voltage of 10 Vp-p 10KHz, while my resolver needs a excitation voltage equal to 7 Vrms at 10 Khz. can I use this kit?

0 Ramesh Ramamoorthy over 6 years ago in reply to Antonio Borelli

TI__Mastermind 27240 points

7Vrms will be 20Vp-p. With a 10Vp-p, the feedback signal from resolver may have a lower SNR. You may need a higher power analog front end, but with 10Vp-p, you can still evaluate, but ENOB may be a bit less.

The TI E2E™ design support forums will undergo maintenance from July 11 to July 13. If you need design support during this time, open a new support request with our customer support center.

C2000™︎ microcontrollers

C2000 microcontrollers forum

TMDSRSLVR: C2000 Resolver to Digital Conversion Kit.