Hi Sal,
iam sending the command line in command prompt ,below is the command line,i don't have any f28334 kernel ,so just i edited f28335 flash kernel name and put it in arguments,please send the f28334 kernel,please have a look at below command line am i doing anything wrong in this command prompt ,please correct me,our controller was TMS320F28334
C:\ti\c2000\C2000Ware_1_00_05_00\utilities\flash_programmers\serial_flash_programmer>serial_flash_programmer.exe -d f2803x -k f28334_flash_kernel.txt -a PQCR.i00 -p COM3 -b 9600 -v
After running the above command in command prompt,it was coming upto "done waiting for kernel boot ...attempting autobaud" after that it was hanging and expecting at the end "Application AutoBaud Successful not coming",please see the below message coming after running command
C2000 Serial Firmware Upgrader
Copyright (c) 2013 Texas Instruments Incorporated. All rights reserved.
getting comm state
building comm DCB
adjusting port settings
calling f05_DownloadImage
Downloading PQCR.i00 to device...
Kernel AutoBaud Successful
Kernel Loaded
Done Waiting for kernel boot...attempting autobaud
Yesterday we tried at customer location,it was not flashed into controller,again we came back..now we are realising we have done a big mistake by selecting this controller for our production,this is really a bad experience for us,we are stuck up here,we already crossed our timeline ,past months am asking.still it was not clear and for after sending message for getting reply it was taking days in TI community
I'm waiting for your kind reply,please reply soon
kindly please help me to sort out this issue,i'm sending screenshots please find the attachment
Because by using c2prog it was flashing into my controller
Thanks & Regards
Gangadhararao G
