CCS/C2000-DIGITAL-CONTROL-LIBRARY: C2000

Fortune Anya

Prodigy 50 points

Part Number: C2000-DIGITAL-CONTROL-LIBRARY

Tool/software: Code Composer Studio

Hi,

How would I go about increasing the soft start in code composer studio for c2000 MCU?

over 6 years ago

0 Richard Poley over 6 years ago

TI__Mastermind 27200 points

To help us assign the question could you elaborate a little what you mean by "soft start" please? Thanks.

Regards,

Richard

0 Fortune Anya over 6 years ago in reply to Richard Poley

Prodigy 50 points

I'm new to C++ programming. I am trying to see how soft start is implemented on css. What would I need to adjust to view the changes on an oscilloscope?

0 Richard Poley over 6 years ago in reply to Fortune Anya

TI__Mastermind 27200 points

We can probably help, but the question is not clear. Does "soft start" refer to a motor, a power supply, or something else?

0 Fortune Anya over 6 years ago in reply to Richard Poley

Prodigy 50 points

I have a solar simulator, load and c2000 micro controller.

0 Manish Bhardwaj over 6 years ago in reply to Fortune Anya

TI__Mastermind 43730 points

Soft start is very specific to the application, For example in PFC it could be just setting the bus voltage slowly to avoid saturation of the voltage loop PI. For LLC it is completely different. Can you elaborate more on the use case, topology etc which can help us point you to an example if we have one.

0 Fortune Anya over 6 years ago in reply to Manish Bhardwaj

Prodigy 50 points

I am trying to figure out how and if soft start could affect the time maximum power point is attained at the load of the set-up I have.

0 Manish Bhardwaj over 6 years ago in reply to Fortune Anya

TI__Mastermind 43730 points

The forum is for C2000 MCU related question, can you elaborate on a specific question you have for C2000 MCU to answer?

I am not sure if i can intelligently comment on an application I have not worked with directly specially if there is not enough details.

The closest i can think of your question pertains to is what we do on TMDSSOLARUINVKIT

see the document here

www.ti.com/.../tidu405b.pdf

When starting the inverter, we first run the DC-DC under a fixed current till the bus voltage is soft started, once it is we start MPPT.

See Fig 46

C2000™︎ microcontrollers

C2000 microcontrollers forum

CCS/C2000-DIGITAL-CONTROL-LIBRARY: C2000