Part Number: LAUNCHXL-F280049C
Tool/software: Code Composer Studio
Hi,
I'm receiving the following error when attempting to flash the DSP:
Error connecting to the target:
(Error -2131 @ 0x0)
Unable to access device register. Reset the device, and retry the operation. If error persists, confirm configuration, power-cycle the board, and/or try more reliable JTAG settings (e.g. lower TCLK).
(Emulation package 8.0.803.0)
I think it may have to do with the way the onboard XDS110 is set up. The User guide recommends using the 2-wire cJTAG configuration, but I cannot figure out how to properly set this up.
Please let me know if you have suggestions.
