TMDSSOLARUINVKIT: TMDSSOLARUINVKIT

Farrukh ibne Mahmood

Part Number: TMDSSOLARUINVKIT

I used the board for the first time and while connecting to the oscilloscope one of the MOSFETs fried, now the board is not working. Can you please give us any assistance in this matter.

over 5 years ago

0 Manish Bhardwaj over 5 years ago

TI__Mastermind 43730 points

Can you elboarte on the exact conditions under which it fried? WHihc test were you running? What was the power level?

0 Farrukh ibne Mahmood over 5 years ago in reply to Manish Bhardwaj

Prodigy 80 points

I was just the first boot up, I connected the ground probe of the oscilloscope to the TP-10 GND, pin and the fried.

0 Farrukh ibne Mahmood over 5 years ago in reply to Farrukh ibne Mahmood

Prodigy 80 points

This fried the borad.

0 Manish Bhardwaj over 5 years ago in reply to Farrukh ibne Mahmood

TI__Mastermind 43730 points

did you connect these while the board was powered?

There is a warning stating not to connect etc. while board is powered.

-Manish

0 Shamim Choudhury over 5 years ago in reply to Manish Bhardwaj

TI__Genius 10995 points

If you have resolved the issue please let us know.

0 Manish Bhardwaj over 5 years ago in reply to Shamim Choudhury

TI__Mastermind 43730 points

Let us know your status, I will close this thread in the interim.

If you have furthre questions start a related thread.

C2000™︎ microcontrollers

C2000 microcontrollers forum

TMDSSOLARUINVKIT: TMDSSOLARUINVKIT