LAUNCHXL-F28027F: How to stop a 3 phase linear motor

Yuval Wulkan

Hi,

I am new to motor control, and I want to understand which signals needs to be in each of the mosfets to make the motor stop at any given point.

I am using the TI Launchpad XL F28027F, with the BoostXL.

Thanks in advanced

Yuval

over 7 years ago

0 Yanming Luo over 7 years ago

TI__Guru** 117160 points

Generally, the PWM signals are connected to MOSFET, to control the ON/OFF of MOSFET/IGBT to run/stop the motor.

If you haven't had a chance to look at the workshop material, I think this will help demystify some of the terminology and architecture as well.
training.ti.com/introduction-motors-motor-control-part-1-introduction

C2000™︎ microcontrollers

C2000 microcontrollers forum

LAUNCHXL-F28027F: How to stop a 3 phase linear motor