F28379D DEBUGGING TARGET MEMORY AND MEMORY MAP ERROR

christian lepac

Part Number: TMS320F28379D

Tool/software: Code Composer Studio

Good day all,

I bought a new F28379D launchpad, since the previous one had some issues. The previous LAUNCHPAD was working fine.

However I have an error while debugging the program. I didn't make any change in CCS platform configuration. Please follow the message error below:

over 6 years ago

0 Vamsi Gudivada over 6 years ago

TI__Guru* 87155 points

Christian,

Did you program passwords for this device? Please check. If yes, you have to unlock for CCS to erase/program/verify the image.

Open the memory window for the address 0x90000 and check whether or not it has valid data that you expect.

Thanks and regards,
Vamsi

0 Vamsi Gudivada over 6 years ago in reply to Vamsi Gudivada

TI__Guru* 87155 points

Christian,

Do you have any update on this?

Thanks and regards,
Vamsi

0 Vamsi Gudivada over 6 years ago in reply to Vamsi Gudivada

TI__Guru* 87155 points

Christian,

Since I did not hear from you, I am assuming this is closed.

If you still need some help on this, you can reply to this thread. If the thread gets locked, you can use the "Ask a related question" button at the top right corner to post your related question.

Thanks and regards,
Vamsi

C2000™︎ microcontrollers

C2000 microcontrollers forum

F28379D DEBUGGING TARGET MEMORY AND MEMORY MAP ERROR