CCS/LAUNCHXL-F28379D: External connection in CLA Hnadson Workshop demo

Jingtai,

We are checking on this issue, will be getting back to you soon

Regards,
Peter

Jingtai,

I am having difficulty understanding your question - could you please provide more detail

You stated that "according to the PCB they should be J30 and J80". What is "they"?

Thanks,
PEter

Peter,

I'm sorry for my mistake. It should be J3-30 (ADCINA0) in table 5 and J8-80 (EPWM4A) in tabe 8. 

Regards,

Jingtai

Peter,

Have you figured out?

Regards,

Jingtai

Jingtai,

Yes, from the information that you sent it appears that there is indeed a mismatch between the drawing the the tables regarding the endpoints of the jumper cable. I have contacted the course designer to provide explanation. In the mean time, have you been at all successful in establishing this connection by following the tables?

Regards,
Peter

Jingtai,

ADCINA0 is header J3, pin #30 (and not pin #9 as shown on the slide)

EPWM4-A is header J8, pin #80 (and not pin #54 as shown on the slide)

EPWM1-A is header J4, pin #40 (just in case you need it)

 You are correct, however you should refer to them as pin numbers rather than ‘J’ which we use for header numbers.

Regards,

Peter