tms320f28335 peripheral explorer kit

Hikmet Fidanboy said:

Hello,

 I have a tms320f28335 peripheral explorer kit. ı want to use this kit with Matlab/Simulink. but there isn't library of the kit in Simulink. this kit runs with c codes in ccs4.0. ı cannot use this kit in Matlab/Simulink. I can run this kit with Matlab/Simulink (F28335 eZdsp) and ccs.3.3, but I cannot take out from this kit. Can I use this kit in Matlab/Simulink? What can I do to use this kit in Matlab/Simulink?

 Sincerely.

Please see the MathWorks official statement on CCS 4 support with MathWorks tools:

http://www.mathworks.com/support/solutions/en/data/1-DM9192/?solution=1-DM9192

In R2010b, Embedded IDE Link supports Texas Instruments Code Composer Studio 4.0 (CCS 4.0) through the use of XMakefile utility. When you generate source code from a model, the XMakefile utility generates a corresponding makefile which you can use with CCS 4.0 to build the embedded software. You can use TI's DSS scripting with CCS 4.0 to load and run the embedded software on supported TI processors. The documentation provides examples for each of these steps. Model and code verification techniques supported for CCS 4.0 include TCP/IP-based processor-in-the-loop (PIL).

Automation of the IDE tasks, debugging, and project generation (as supported with CCS 3.3) are not available for CCS 4.0.

You may also wish to contacts MathWorks support at c2000_expert@mathworks.com.

Regards,

Lori