C2000-GANG: C2000-GANG software stops working when I try to program C28 file

Gustavo Lima1

Part Number: C2000-GANG

Hi,

I am trying to program F28M3x Concerto with a C2000-GANG programmer, with files in .hex format. ARM file is normally programmed, but when I try to program C28 file, the C2000-GANG software stops working and I can not finish the process.

How can I solve this?

Regards,

Gustav

over 6 years ago

0 Vamsi Gudivada over 6 years ago

TI__Guru* 87155 points

Gustav,

What error did you get?

Please try using --memwidth=16 --romwidth=16 --intel options in C2000 hex utility.

Let me know if it does not help.

Thanks and regards,

Vamsi

0 Vamsi Gudivada over 6 years ago in reply to Vamsi Gudivada

TI__Guru* 87155 points

Gustav,

Since I did not hear from you further, I assume this is resolved. I am closing this post. If you have further questions, please open a new post.

Note: I will not be available until December 3rd. Hence, please expect delays in our replies in case you reply with a follow-up question on this thread.

Thanks and regards,
Vamsi

C2000™︎ microcontrollers

C2000 microcontrollers forum

C2000-GANG: C2000-GANG software stops working when I try to program C28 file