TMS320F28379D: TMS320F28379D

could you please give me more information how can i read this data using JTAG scan?

is there doc to get more information?

can you please response?

can you please response the below question?

thanks,

Itay

Abraham,

Sorry for the delay, to read this data using a JTAG scan, I would recommend to use a BSDL scan tool such as XJTAG:

1. Download and install the JTAG tool from XJTAG (https://www.xjtag.com)
2. Download BSDL file for F2837x from ti.com product folder
3. Connect F2837x part to JTAG tool, power up part
4. Run JTAG tool and load BSDL file
5. Click on any of the device pins to drive ‘1’ to pin or to drive ‘0’
6. Refer to XJTAG instuctions how to perform other tests

JTAG tool can interactively drive the IOs to be ‘1’ or ‘0’ and you should be aware to what is externally connected to the IOs in their target board for you to be able to use this JTAG tool in debugging their HW.

Regards,

Peter

Hello,

I'm using JTAG Technologies tools to perform the test.

All the details above already done. The issue is how to get the data in the result register that store the information of the built in ADC.

There is no information in the data sheet of the device.

Thanks,

Itay

Can you please response to the message below?

Itay,

I apologize for the delay,  the BSDL file addresses the input / output buffers that receive/send data through I/O pins. Are you trying to access other registers than pin registers?

Regards,

Peter