• State
  • Locked Locked
  • Replies 3 replies
  • Subscribers 81 subscribers
  • Views 551 views
  • Users 0 members are here
Support feedback
Options
Options
Related

This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

Recommendation for MCU

Li Chen92
Expert 3040 points

Other Parts Discussed in Thread: TMS320F28379D, LAUNCHXL-F28379D, TMDSCNCD28379D, TMDSDOCK28379D

HI TI expert

The TMS320F28379D I use does not have the ADC for Negative portion of the signals. Can you recommend any launchpad product of similar dimension ( can be larger - but not too much or smaller than TMS320F28379D ) that has ADC for negative portion also ?

Best regards,

Thomas

  • 0
    TI__Mastermind 45606 points

    Hi Thomas,

    The F28379D has 16-bit differential ADC inputs if that is what you're asking about. I recommend looking at the device datasheet and Reference Manual for more details on the functionality if needed.

    The LAUNCHXL-F28379D has some of the ADCD inputs routed for differential input. Also a differential amplifier (U1) on board for ADCIND4 AND ADCIND5 inputs to SMA connector pads.

    Best,

    Kevin

  • 0 in reply to Kevin Allen18
    TI__Expert 3040 points

    Hi Kevin

    Thank you very much for your response. Yes, I can use the differential ADCs. However, in that case, I need 6 pairs of them on one board (6 separate signals). Does LAUNCHXL-F28379D has the provision ? If not, can you recommend me some other launchpad of TI that has that provision.
    Alternatively, I can use a differential OpAmp outside and put an offset - however, that'll take up a large portion of my PCB and also requires additional DSP programming. That's why I'm looking for a module that has 6 pairs of differential ADCs / adc with negative signal sensing capability.

    Best regards,

    Thomas

  • 0 in reply to Li Chen92
    TI__Mastermind 45606 points

    Hi Thomas,

    The LAUNCHXL-F28379D circuitry I showed has 6 signals (3 differential pairs). One of the pairs goes to the differential Amp and SMA connectors. This is the only C2000 LaunchPad that has differential ADC capability.

    You can take a look at the TMDSCNCD28379D ControlCard + base board (see TMDSDOCK28379D). Most, if not all, of the ADC signals are routed differentially, however no external amplifier circuitry is included on the board.

    Best,

    Kevin