Сode from a file slac139g does not work with the program eZ430-RF2500 SEH Sensor Monitor v.2.5

Denis Petrov

Hello. I work with device MSP430 eZ430-RF2500-SEH .When I bought device where was already code. It works well with eZ430-RF2500 SEH Sensor Monitor v.2.5. But after I loaded back code from a file slac139g in this version does not work. Operate only the older version 1.0.6. I understand the code which site is older than the one that was first on the device. How to make the code work with the new version of the program?

over 10 years ago

0 Ryan Brown1 over 10 years ago

TI__Guru**** 222137 points

Denis,

I am currently looping in a TI engineer who knows more about the eZ430-RF2500 and will be able to help answer your question. Please allow him time to formulate a response.

Thanks,
Ryan

0 Denis Petrov over 10 years ago in reply to Ryan Brown1

Prodigy 40 points

Ryan,
Ok. I will be wait answer.

0 Eric Chen over 10 years ago in reply to Denis Petrov

TI__Genius 9220 points

Hi Denis,

It sounds like you're trying to use the GUI from slac219 with the AP/EP firmware from slac139.

I looked at the software included in these packages, and while similar, the Access Point applications included in these 2 packages actually send slightly different serial data to the PC. Both of these packages include their own GUI that works correctly with their respective firmwares. The serial data are formatted differently between these two projects most likely because they were developed in different circumstances.

I confirmed that eZ430-RF2500 Sensor Monitor GUI from slac139 is able to pick up on the serial data sent from the Access Point software from slac219 and display nodes properly.
However, the eZ430-RF2500-SEH Sensor Monitor GUI from slac219 is not compatible with the serial data formatted in the Access Point software from slac139.

Hope that answers your questions.

Regards,
Eric C.

**Attention** This is a public forum

MSP low-power microcontrollers

MSP low-power microcontroller forum

Сode from a file slac139g does not work with the program eZ430-RF2500 SEH Sensor Monitor v.2.5