ez430-rf2500 development tool interface with the PIC microcontoller.

dhir patel

Other Parts Discussed in Thread: CC2500

hy,

I am trying to develop the wireless security system using the ez430-rf2500 development tool.

so i am trying to interface with SPI protocol. but i wanted to know that how the data will be communicate in system?

And if i will use the 18 accessible pins for that?

please Help me immidiately.

thanks...

0 Antonio Espirito-Santo over 13 years ago

Expert 2855 points

Hi,

You need to be more specific if you want to receive valuable help.

The eZ430-RF2500 can interface another MCU through the J1 connector (RX/TX mode).

Best Regards,

AES

0 dhir patel over 10 years ago in reply to Antonio Espirito-Santo

Hi AES,

Thank you for your reply back in 2012.

Sorry I didn't thank you at that time.

But if you can help me now then it would be very appreciated.

Now I am working o the same project and this time I want to communicate CC2500 chip with the PIC16f micro controller.

Can you help me with this?

0 Antonio Espirito-Santo over 10 years ago in reply to dhir patel

Expert 2855 points

Hi,

Can you now be more specific?

Best Regards,
AES

**Attention** This is a public forum

MSP low-power microcontroller forum