Question: Interrupts are blocked in my application when when the compiler uses the RPT (repeat a single instruction). How can I limit the number of times RPT is applied to an instruction or tell the compiler to not use RPT so that interrupts get through…

Part Number: MSP430I2020 Tool/software: TI C/C++ Compiler Test condition: - MSP-TS430RHB32A board - GAIN 1 - Measuring result = 10 data average - sample program "sd24_ex4_singleConversionSingleChannelPolling" - supply volt.: 3.3V (Tenma…

Part Number: MSP-GANG Hello! We are excited to announce a new software update for the MSP-GANG device! Thanks to this new update, programming times have dropped by a substantial amount (up to 32.1% on certain devices)! For those of you who may not…

Other Parts Discussed in Thread: TMS320F28377D Question: What is the DMIPS of a C28x device?

Part Number: MSP430F6736 Tool/software: Code Composer Studio Hi team, I am using the following example code for SD24 converters from the resource explorer: #include <msp430.h> #include <stdio.h> /* Array to store SD24_B conversion results…

How do I choose whether to use up-down or up-and-down mode for the ePWM module?

Why do my software breakpoints keep disappearing? I have a breakpoint set in code which is loaded into Flash and then runs from RAM. The breakpoint is set in RAM region where the code runs. Sometimes this breakpoint halts the code, sometimes it does…

While debugging an if statement, why is the statement within the "if" always executed?

Part Number: MSP432WARE Other Parts Discussed in Thread: CC2640 , CC3100 , MSP432E401Y Hello, I have some difficulties to fully understand which product fits my use case. As an software engineer, I am new to electrical engineering, so please excuse…

Part Number: MSP430FR4133 Other Parts Discussed in Thread: MSP-EXP430FR4133 , BOOSTXL-BATPAKMKII We have discovered an issue on some MSP-EXP430FR4133 LaunchPad where the male pins on the J1, J2, and J3 headers (the BoosterPack headers) were clipped…