Eval Board for FOC using hall sensors

Ian Aherne

Other Parts Discussed in Thread: C2000WARE-MOTORCONTROL-SDK, C2000WARE

Hello

Is there a motor driver evaluation board/ MCU board combo that can be used for Field oriented control using hall sensors for a 12/24 volt BLDC motor,

I am specifically looking for something with sensored FOC software available.

Regards

Ian

over 3 years ago

+1 Yanming Luo over 3 years ago

TI__Guru** 115420 points

You may download and install the latest MotorControlSDK, and the detailed introduction about the lab can be found in the lab user’s guide as the links below. The lab can support the sensored-foc with hall sensor on a set of the kits.

C2000WARE-MOTORCONTROL-SDK: https://www.ti.com/tool/C2000WARE-MOTORCONTROL-SDK

Universal Project and Lab User’s Guide: https://www.ti.com/lit/spruj26

Example lab project at the folder: C:\ti\c2000\C2000Ware_MotorControl_SDK_3_03_00_00\solutions\universal_motorcontrol_lab\f28002x

0 Ian Aherne over 3 years ago in reply to Yanming Luo

Prodigy 200 points

Great thanks

Motor drivers

Motor drivers forum

Eval Board for FOC using hall sensors