capture raw command

Taylar Huang

Other Parts Discussed in Thread: TDA4VH

Dear TI experts,

I'd like to capture raw for TDA4VH isp tuning. May I know if I should use any command to capture raw image?

Thanks~

0 Gang Hua over 2 years ago

Hi,

If you use tuning tool with eth, please refer to section 10 in https://www.ti.com/lit/pdf/spracu7

If you only use single-cam app, you may look at the command interface after kicking off the app.

0 Taylar Huang over 2 years ago in reply to Gang Hua

Hi Gang Hua,

Could yu help to check which IP address is right for camera to capture raw?

Thanks!

+1 Gang Hua over 2 years ago in reply to Taylar Huang

Your PC and EVM must be on the same local network and they shall be able to ping each other.

When you start the single-cam app, it will also print out the IP address.

0 Taylar Huang over 2 years ago in reply to Gang Hua

Hi Gang Hua,

Do you mean EVM also be link to the network?

0 Gang Hua over 2 years ago in reply to Taylar Huang

Yes, EVM and the PC tuning tool communicate over eth.

Motor drivers forum