Hi
I've asked for help a few times, but there's no clear answer, so I'm asking you again
I have a DRV2625 demo machine
I want to drive it by inputting the Square half wave into the vibration motor
International patents are currently being reviewed, and various experiments are required for this.
As far as I know, it is possible to input square and half waves with demo equipment.
Please tell me how to set it
Hello
I also have DRV2624EVM-CT.
Please support me on how to create a waveform.
Thank you.
Hi Lee,
Once the EVM is connected, open File -> RAM Manager -> DRV2624
Right click "waveforms" in the window and click "Add"
This will open a window where you can enter in the amplitude (in hex) and how many time intervals this point will last (also in hex)
You can repeat this process, adding "points" to the effect until you've created the effect you wanted. After you are done, click "Write RAM" to load the effects into the EVM. You can export the RAM to a file for use later or on a different system.
Best regards,
Jeff McPherson
