Communication protocol between PC and DRV8811 EVM board?

remus haupt

Other Parts Discussed in Thread: DRV8811, DRV8811EVM

Hi Ti

We have purchase DRV8811 EVM board and used the "DRV8811EVN 001 evaluation platform" software, but need more control over timing for start/stop, so we actually can make a program for diffrent speeds

Do you have a communication protocal?

thanks

Remus

over 14 years ago

0 Jose Quinones over 14 years ago

TI__Expert 7455 points

Hi Remus,

If you write to my email address jquinones@ti.com, I will reply with the MSP430 source code. You can see all the available opcdes and the structure if you look at the TASK0.cpp code file. There is no document detailing all the commands, but it is fairly simple to follow.

I can also help you with any other question while looking into this code.

Best regards,

Jose Quinones

0 Jose Quinones over 13 years ago in reply to Jose Quinones

TI__Expert 7455 points

Hi All,

From now on, you can find all of the DRV8811EVM documentation and source code here: http://www.ti.com/tool/drv8811evm. Do let us know if there is anything else we can help you with!

Best regards,

Jose Quinones

Motor drivers

Motor drivers forum

Communication protocol between PC and DRV8811 EVM board?