DRV8889-Q1EVM: GUI does not work

Keith Barkley

Part Number: DRV8889-Q1EVM
Other Parts Discussed in Thread: MSPM0L1306

Tool/software:

I have everything plugged in - I used the GPIO toggle example to update the firmware in the MSPM0L1306 XDS110 - but I keep getting the error:

But that file exists:

Am I doing something wrong?

over 1 year ago

0 Keith Barkley over 1 year ago

Guru 42145 points

Just for the record, the gui for the built-in MSP430 works fine.

0 Eason Zhou over 1 year ago in reply to Keith Barkley

TI__Mastermind 39775 points

Can you download it manually and try again. It may be some problem with the code downloading with the GUI.

0 Keith Barkley over 1 year ago in reply to Eason Zhou

Guru 42145 points

That is one thing I am not clear on, do I need to flash the code to the MCU. or is it done for me?

0 Keith Barkley over 1 year ago in reply to Eason Zhou

Guru 42145 points

Also, what do I *do* with it? put it in the workspace?

0 Keith Barkley over 1 year ago in reply to Eason Zhou

Guru 42145 points

I created a new workspace that contains only this firmware, click the link in the doc, and get the same error.

0 Keith Barkley over 1 year ago in reply to Eason Zhou

Guru 42145 points

I am not 100% sure I am out of the woods, but when I clicked the "open in system browser icon" and it connects when run in the browser and not in the CCS Resource Explorer window. Now to hook up my motor...

0 Eason Zhou over 1 year ago in reply to Keith Barkley

TI__Mastermind 39775 points

So, when you open the GUI in browser, the GUI will try to program the MSPM0. As it use UART to connect MSPM0, it need to program it first.

See your picture, it shows the GUI program the MSPM0 failed. That is why I let you to program manually.

+1 Keith Barkley over 1 year ago in reply to Eason Zhou

Guru 42145 points

Using the "open in browser button" did it. For some reason it could not run in CCS. Thanks.

Motor drivers

Motor drivers forum

DRV8889-Q1EVM: GUI does not work