Tool/software:
Hi,
According to datasheet Half bridge control table if i am using PWM then how the High side drive load will be continuous ON?
My required condition is continuous below condition
SH1 - H
GH1 - H
GL1 - L
Regards,
Brijesh
This thread has been locked.
If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.
Tool/software:
Hi,
According to datasheet Half bridge control table if i am using PWM then how the High side drive load will be continuous ON?
My required condition is continuous below condition
SH1 - H
GH1 - H
GL1 - L
Regards,
Brijesh
Hi Brijesh,
The half bridge control can be achieved by nHiZ1 = 1 and IN1/EN = 1. Please see the snap shot from datasheet of DRV8106H.
Controlling the inputs can be seen from the EVM Users Manual.
Hope this clarifies.
Thanks,
Ibinu