DRV10987EVM: GUI Lead time not selectable

Hi Philippe,

What is the commutate advance control mode? IS it constant or dependent?

Thanks and Best regards

Venkatadri S

Hi,

We have the same problem with constant or dependent mode.

Kind regards

Philippe

Hi Philippe,

Looks like there is some issue with GUI.

I am able to enter the value.

Can you provide details about the environment, whether you are able to install LabView run time properly?

Thanks and Best regards

Venkatadri S

Hi,

Which details about the environement do you need ?

I will check config of labview on another PC.

Best regards

Philippe

Hi Philippe,

I meant PC OS, Labview run time details.

You can check and confirm.

Thanks and Best regards

Venkatadri S

Hi,

My PC OS is Windows 10 professional, version 22H2.

We have another problem, when we start applicatin, we have this error message :

DRV10983 USB2ANY.lvclass:Write Register.vi<ERR>
Register writing not successful!! Please restart the GUI and try again

Do you think that it's also a problem with Labview ?

Kind regards

Philippe

Hi Philippe,

Yes, this VI error which is backend engine LabView .

Did you try with another PC?

Please follow this thread (+) DRV10975EVM: How to install the software - Motor drivers forum - Motor drivers - TI E2E support forums

Thanks and Best regards

Venkatadri S

Hi,

Yes, we try with two another PCs.

I have followed the documentation but there is 4 Labview 2014 version on NI Labview site:

- 2014

- 2014 PATCH

- 2014 SP1

- 2014 SP1 PATCH

Which must be installed ?

32 bits or 64 bits

Kind regards

Philippe

Hi Philippe,

Use 32 bit 2014.

Thanks and Best regards

Venkatadri S

Hi Philippe,

Any progress?

Thanks and Best regards

Venkatadri S