DRV8312 Kit

You will get a NEMA 17, 24V, PMSM motor, 55W with the kit.  This is described under the "What's Included" table on the website.

http://www.ti.com/tool/drv8312-c2-kit

Thanks for the reply sir, But in Hardware Guide they have mentioned in the we will get BLDC thats what confused . in that link what you posted that also shows like 1 NEMA17 BLDC/PMSM 55W Motoronly right...

We use the terms BLDC and PMSM in the documentation interchangeably.  The motor has a sinusoidal back EMF, but can be driven with a trapezoidal technique or full FOC.  The kit includes software (firmware and GUI) to test out both with the included motor.  

I have a related question about the included motor:

I'd like to use this kit for feedback control of a stick-balancing cart. For the feedback I intend to add a shaft encoder. Will the motor in the kit be double-ended, so I can mount the shaft encoder to the back while driving a load in the front?

Hi All,

I have a DRV8312-C2-Kit and want to start my own circuit board design from there and replace DRV8312 by DRV8332.

The PCB design file will be a good starting point for me to save lot of time. But, I can not find it, only PDF format for schmatic and gerber files are available.

Could someone advise me if the PCB design file for DRV8312-C2-Kit available ? No matter it is by Allergo, Alitum, CadStar, or ..

Thanks & Best Regards,

Edward