DRV8837 Eagle Footprint and Symbol

Mehrdad Majzoobi

Prodigy 90 points

Other Parts Discussed in Thread: DRV8837

I can't find the footprint and symbol for DRV8837 motor driver.

http://www.ti.com/product/drv8837

Can someone help please?

Thanks,

Mehrdad

over 12 years ago

0 Ryan Kehr over 12 years ago

TI__Guru 55615 points

Mehrdad,

Please scroll down near the bottom of the page at the link below:

http://www.ti.com/product/drv8837

You will find a section under CAD/CAE heading. Please follow the instructions given on the page and I hope it helps. That is all we have that I know of.

0 Mehrdad Majzoobi over 12 years ago in reply to Ryan Kehr

Prodigy 90 points

Thanks Ryan! I don't know why I missed that part.

0 Tohru Nanri1 over 12 years ago in reply to Ryan Kehr

Prodigy 20 points

Ryan-san,

I found missing dimensions (both height and width) on expose pad in WSON8 datasheet. How much are these dimensions?

0 RE over 12 years ago in reply to Tohru Nanri1

TI__Mastermind 20985 points

Tohru-san, are you asking about the DRV8837 thermal pad dimensions? This is described on datasheet page 12. Nominal is 0.9 x 1.6 mm.

Best regards,
RE

0 Tohru Nanri1 over 12 years ago in reply to RE

Prodigy 20 points

Thank you a lot. Should I make a board layout for only DRV8837 in same as DSG packages?

0 Nicholas Oborny over 12 years ago in reply to Tohru Nanri1

TI__Mastermind 21320 points

Yes,

The recommended land pattern is shown on the next page (pg 13)

-Nick

Motor drivers

Motor drivers forum

DRV8837 Eagle Footprint and Symbol