• State
  • Locked Locked
  • Replies 1 reply
  • Subscribers 30 subscribers
  • Views 557 views
  • Users 0 members are here
Support feedback
Options
Options
Related

This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

DRV2605L Control2 register default values

wilfrid
Prodigy 220 points
Other Parts Discussed in Thread: DRV2605

Hello all,

There are incoherence on page 45-46-47 of the DRV2605 datasheet, on the default values.

The register summary gives 0x01 for blanking and idiss time, but the default values in the table below are 2. I think the summary is ok as the values are the same in the auto calibration chapter.

Could you give me the right values?

Best regards,

Wilfrid

  • 0
    TI__Intellectual 945 points
    HI Wilfrid,

    Yes, you're right. Thanks for bringing this to our attention. The default (and recommended) value for IDISS time is 0x01 (Register 0x1C[1:0] = 1). You can refer to subsection 7.5.6 of the datasheet for confirmation.

    We will update the datasheet to correct this mistake.

    Regards,
    Leo Rodriguez
    ARP - Haptics