DRV2605LEVM-MD: DRV2605LEVM-MD

Abdiaziz Mohamud

Part Number: DRV2605LEVM-MD

I have purchased the DRV2605LEVM-MD board and it won't turn on. I have been following the haptics control console and I can't seem to turn on the board when i connect it to the computer via USB.

www.ti.com/.../slou502.pdf

over 6 years ago

0 Micah B Brouwer over 6 years ago

TI__Intellectual 1910 points

Hey Abdiaziz,

Did you hold down USER SW until LED1 turns on before connecting to Haptic Control Console via USB?

Does HCC recognize the board at all?

0 Abdiaziz Mohamud over 6 years ago in reply to Micah B Brouwer

Prodigy 45 points

Thank you for getting back to me.

that worked for me. I will like to control 4 motors independently, is that doable? If so, how do I go on doing that?

I want to write a code that will input a value and that will cause only one or two of the 4 motors to vibrate.

0 Kelly Griffin over 6 years ago in reply to Abdiaziz Mohamud

TI__Expert 8832 points

Hi Abdiaziz,

You can individually control each driver using HCC and the Driver or Settings tab.

Motor drivers

Motor drivers forum

DRV2605LEVM-MD: DRV2605LEVM-MD