DRV2667: Connection the DRV2667EVM with USB2any in I2C

Adam Koloff

Part Number: DRV2667
Other Parts Discussed in Thread: USB2ANY,

Hello Team,

I'm wanting to use the Haptic Control Console to control the DVR2667 EVM via USB2ANY. However, I'm not certain which firmware file to use for flashing USB2ANY. I downloaded the DRV-USB-COM Board Firmware, but couldn't find the necessary guidance in the HCC or USB2ANY user guides.

Thank you in advance,

over 7 years ago

0 Kelly Griffin over 7 years ago

TI__Genius 10532 points

Hi Adam,

Please look in the Haptic Control Console (HCC) user guide for this information. You can flash the firmware using just HCC.

0 Adam Koloff over 7 years ago in reply to Kelly Griffin

Prodigy 20 points

Thanks for the reply, Kelly. I somehow missed Section 6.1 step 4 which called out the correct firmware file. It is now connected, so thank you. I guess I must of mentally been scanning for a firmware filename that had "DRV2667" in the name. Thanks again.

Motor drivers

Motor drivers forum

DRV2667: Connection the DRV2667EVM with USB2any in I2C